
A guide on how to make the, HP DPS-800GB Rev. A, server power supply run outside of its server enclosure. A simple bridge between pin 31 and 34 is required and it is important to NOT drill holes through the GND and +12VDC output pads, this will risk short-circuiting the output as its a 4-layer PCB.
Discussion and schematic: https://highvoltageforum.net/index.php?topic=1155.0
↝↝ Additional information and links ↜↜
★ Partners: @ArcAttack! and @Franzoli Electronics
★ Music by Mikas: https://www.facebook.com/mikasdk/ (used with commercial permission)
★ T-Shirts, mugs and other merchandise: https://teespring.com/stores/kaizer-power-electronics
★ Electronics website: https://kaizerpowerelectronics.dk
★ Facebook: https://www.facebook.com/kpedk/
★ High Voltage Forum: https://highvoltageforum.net
★ My Slow motion videos channel: https://www.youtube.com/channel/UCB2qu77PCr5i9zcs0sOhp4w
★ Find me at Odysee: https://odysee.com/@KaizerPowerElectronics:9 and https://odysee.com/@SlowMotionVideos:5
★ Find me at LBRY: https://lbry.tv/@KaizerPowerElectronics:9
$ For commercial/non-commercial licensing of material, contact through here: http://kaizerpowerelectronics.dk/about/contact/
♥ Donations
Please consider one of the following:
♥ Donate via Paypal: fleex@disorder.dk
♥ Donate crypto currency directly on these addresses (Check if there is minimums before transfer):
• Bitcoin: 36gKDS4PfmPdmi2YC9kRASNV9Au8rUXbBS
• Litecoin (old): 3MHsQ1xhPvoqUv51dXJHAHZf2QXLZ7UEbo
• Litecoin (new): MTW1huNfM3fGHRLujQHcyvp4M77nYpLTGF
#server #psu #diy
0 Comments